Holy fuck.....!!!! I wish I was good at sharpying bikes!

 probably use alcohol wipes or something to remove it and redo it?

 if its a big messup i usualy try to get the alcohol to it fast, if that doesnt work which it usualy doesnt, because once industrial sharpie dries fully, about 30 seconds its there for life no matter what u have to take it off, unless u want the base paint gone too. otherwise i just turn the messup into another peice of the design.

 So this is super precision O.o

 $300 for a complete frame including clear coat, takes 40 hours

 what about like part of the frame like some of the CoC frames you did, so like only the headtube and a few other parts are done.

 it would be around half the cost.

 You work for $300 for 40 hours of work??? That's $7.50/hour! Minimum wage is $10.25/hour! And that's not even including materials!

 and some people still dont put the cost and hours of work together =P, thanks

 You've got some serious skills. Learn to market yourself well and you can make some good money with your talent. Don't sell yourself short! If people won't pay more than $300 for a frame, then you need to figure out how to do it faster. And if you can't do it faster, you need to figure out how to charge more! Seriously... people will pay for quality work, and this is quality work!

 the comments further up say's that he clear coates them after

 Oh right, nice, maybe I should get him to do a design on my roadie!! haha