krisboats

After having these questions deleted from your facebook page i figured i'd pose them here, where you have no ability to sweep them under the rug. You state you want an easier to set up solution where you can fit it and change angles but without having to set up the angle of the gopro each time you relocate it. Then you use the standard gopro case and screw attachment. If you switch from a helmet cam to a chest cam the angles are going to be different, so you still need to unscrew the gopro thumb screw and reposition the camera. The vibration DAMPING is mentioned but you show no before/after for vibration reduction. In fact, the footage doesnt seem to show much vibration difference at all. Sure you've made the camera relocation a little quicker, but the mandate says people were fed up and wanted a tool free system. Gopro original mounts ARE TOOL FREE! So basically, you can relocate a little quicker. You still need to adjust the camera angle and set it up everytime you use it. Its hella more expensive. Its modular for fitting some fairly basic led lights. How is this an improvement? Surely a rugged motor based steadycam bracket would have been better?