Rawing powder coated parts ?

PB Forum :: BMX (20")
Rawing powder coated parts ?
  • Previous Page
  • Next Page
Author Message
flag gibby199
Posted: Oct 9, 2011 at 12:36 Quote
yeh i was wondering if it is going to be any harder to remove the paint ?
flag rossdescairns
Posted: Oct 9, 2011 at 16:33 Quote
Its not paint and its baked on so it will be very difficult, not impossible but still hard.
flag
Posted: Oct 10, 2011 at 19:52 Quote
Its not hard, ive done it 100+ times. Can take a lil bit of time, less then a hour.

All you need is Paint stripper/steel wool and sum gloves. Sand paper sucks but i suppose itll work. High grade steel pads work great..same with SOS pads and certain pad cleaners. but paint stripper is the Key.

You can raw a frame within 45 mins or less with good stripper.

just make to sure clear it if ur leaving it raw.
flag gibby199
Posted: Oct 10, 2011 at 23:30 Quote
LordRain wrote:
Its not hard, ive done it 100+ times. Can take a lil bit of time, less then a hour.

All you need is Paint stripper/steel wool and sum gloves. Sand paper sucks but i suppose itll work. High grade steel pads work great..same with SOS pads and certain pad cleaners. but paint stripper is the Key.

You can raw a frame within 45 mins or less with good stripper.

just make to sure clear it if ur leaving it raw.

Thanks for the advice Smile !
flag eulis
Posted: Oct 16, 2011 at 1:39 Quote
if you haven't already rawed it, just buy some emery(wet and dry paper) from a hardware store, it only costs about 50p,
you will also want to lacquer it after to prevent it from rusting
  • Previous Page
  • Next Page

 


Copyright © 2000 - 2024. Pinkbike.com. All rights reserved.
dv65 0.009706
Mobile Version of Website