Post Your Specialized SX

PB Forum :: Post Your Ride
Post Your Specialized SX
Author Message
flag prezes1984
Posted: Sep 6, 2020 at 6:14 Quote
suechtiger wrote:
finally done Smile

....

nice
flag enorbz
Posted: Sep 6, 2020 at 9:05 Quote
suechtiger wrote:
finally done Smile

photo
Looks so good mate! I wish specialized would make this bike again!! The status just isn’t the same at all!
flag sterlingmagnum
Posted: Sep 6, 2020 at 9:28 Quote
Agreed... here was mine. I loved this thing...

New Air Conversion
flag whattheheel
Posted: Sep 8, 2020 at 13:54 Quote
suechtiger wrote:
finally done Smile

photo

Congrats on Vital's Bike Of The Day!!!
flag enorbz
Posted: Sep 8, 2020 at 14:02 Quote
Well deserved that bike brings back so many good shred session I miss mine everyday and this build is just beyond dialed
flag whattheheel
Posted: Sep 8, 2020 at 14:06 Quote
I am still so mad at myself for selling this one. Excuse the potato.
photo
flag enorbz
Posted: Sep 8, 2020 at 14:08 Quote
whattheheel wrote:
I am still so mad at myself for selling this one. Excuse the potato.
photo
Not at all man my good friend had that same frame when we were coming up in dirt jumping that thing was so fricking rad and still is
flag whattheheel
Posted: Sep 8, 2020 at 14:13 Quote
I got a buddy down in Houston I am going to make sell me his!! Or else!!
flag whattheheel
Posted: Sep 8, 2020 at 14:17 Quote
photo
photo
Specialized sx
She saw a few different builds on it.
flag whattheheel
Posted: Sep 8, 2020 at 14:34 Quote
Yeah, I really wish the Hammerschmidt didn't rob so much juice. Makes wonder about the new Classified (?) 2 speed hub for sure.
flag sterlingmagnum
Posted: Sep 8, 2020 at 15:01 Quote
whattheheel wrote:
I got a buddy down in Houston I am going to make sell me his!! Or else!!

You’re close Wink
flag bjellys
Posted: Nov 14, 2020 at 10:12 Quote
Just a tip If you are changing the the bearings on a SX1 the rear pivots have 2 bearings each side so there is 2 that go in from the inside and 2 from the outside with solid space in the middle I only found this out while removing all the frame bearings ready for powder coating.
I manage to bend the end of a screwdriver ground the end to the shape needed then tapped them out with a small hammer.
All the other bearings are single bearings I also got the numbers off the bearings and then ordered of Amazon at a greatly reduced price.
I hope this helps

 


Copyright © 2000 - 2024. Pinkbike.com. All rights reserved.
dv56 0.017315
Mobile Version of Website