Boxxer steerer tube length

PB Forum :: Downhill
Boxxer steerer tube length
Previous Page | Next Page
Author Message
Posted: Oct 9, 2020 at 9:29 Quote
Hey Guys,

Picked up a used Boxxer.. I’m a little concerned with the steerer length once installed.
After getting as close as I could to rockshox recommended 156mm crown spacing I ended up at 153mm, so I’d like to not remove any spacers below the top crown.

As you can see the steer tube is about 3mm below the top of the crown and leaves 10mm clamped. I know single crown forks are usually set up like this but being a dual crown I am slightly concerned..every other dual crown I’ve seen goes fully through the crown and has spacers above.



Am I going to die? Is it okay to ride?.. I really don’t want to buy a new lower crown

Thanks

Posted: Oct 16, 2020 at 8:23 Quote
That is fine dude, no problem there, if it was 5 plus mm below the crown I might be worried.

Posted: Oct 17, 2020 at 19:14 Quote
bigburd wrote:
That is fine dude, no problem there, if it was 5 plus mm below the crown I might be worried.

Thanks man!!

Previous Page | Next Page

 
Copyright © 2000 - 2020. Pinkbike.com. All rights reserved.
dv56 0.006038
Mobile Version of Website