I’ve watched the video and read through the pdf but I think I’m missing something. When I swapped my lever there is significant play between the pin that presses the master cylinder and the reach adjust screw. Is the spring not in properly? I can’t figure it out so any tips are appreciated, thanks!
There should be a little spring in there to keep tension on the lever. It’s a pain in the ass to get it in correctly. This is the best video I have seen addressing it.
There should be a little spring in there to keep tension on the lever. It’s a pain in the ass to get it in correctly. This is the best video I have seen addressing it.
https://m.youtube.com/watch?v=HoaJ80WZY84
Thanks! I missed that little part of the spring wrapping around the cylinder body in the video and photos I referenced. Definitely a pain but resolved the issue.