Magura MT 5 Lever Swap

PB Forum :: Mechanics' Lounge
Magura MT 5 Lever Swap
Previous Page | Next Page
Author Message
Posted: May 16, 2022 at 19:21 Quote
I’ve watched the video and read through the pdf but I think I’m missing something. When I swapped my lever there is significant play between the pin that presses the master cylinder and the reach adjust screw. Is the spring not in properly? I can’t figure it out so any tips are appreciated, thanks!

Posted: May 16, 2022 at 19:45 Quote
There should be a little spring in there to keep tension on the lever. It’s a pain in the ass to get it in correctly. This is the best video I have seen addressing it.

https://m.youtube.com/watch?v=HoaJ80WZY84

Posted: May 16, 2022 at 21:13 Quote
Branmuffin wrote:
There should be a little spring in there to keep tension on the lever. It’s a pain in the ass to get it in correctly. This is the best video I have seen addressing it.

https://m.youtube.com/watch?v=HoaJ80WZY84

Thanks! I missed that little part of the spring wrapping around the cylinder body in the video and photos I referenced. Definitely a pain but resolved the issue.

Previous Page | Next Page

 
Your subscriptions
no posts

Copyright © 2000 - 2022. Pinkbike.com. All rights reserved.
dv56 0.005781
Mobile Version of Website