Peg problems

PB Forum :: BMX (20")
Peg problems
  • Previous Page
  • Next Page
Author Message
Posted: Mar 22, 2010 at 19:28 Quote
Hey everybody, Iv'e been trying to put my pegs on for a very long time and ive always run into the same problem. I put my rear peg on but when i tighten it my tire shifts to the left of my frame and rubs on that brake pad or to the right of my frame and rubs of my right brake pad. So all in all im pretty much stopped in my tracks. Also Iv'e only gotten it put on successfully once but then my chain ends up loose as hell. Have any ideas???Confused

Posted: Mar 23, 2010 at 5:35 Quote
the way i've always done it is to stick the handle of a crescent wrench,ratchet or hammer in between the chainstay and tire and lever the wheel to the middle while tightening the axle nut

Posted: Mar 23, 2010 at 9:08 Quote
Tighten both nuts equaly, Ie dont do one until its fully tight, tighten one a little bit then do the other side a little bit, and so on.

  • Previous Page
  • Next Page

 


Copyright © 2000 - 2024. Pinkbike.com. All rights reserved.
dv56 0.007049
Mobile Version of Website