After you have adjusted the hub bearings, slip the 14mm wrench on the left side axle and use the 17mm cone wrench to tighten the drive-side endcap (snug is good, don't overdo it). Slide the let-side endcap onto the axle and then snap it into place with hand pressure.
You must login to Pinkbike.
Don't have an account? Sign up

Join Pinkbike  Login
After you have adjusted the hub bearings, slip the 14mm wrench on the left side axle and use the 17mm cone wrench to tighten the drive-side endcap (snug is good, don't overdo it). Slide the let-side endcap onto the axle and then snap it into place with hand pressure.

0 Comments


Post a Comment



Copyright © 2000 - 2019. Pinkbike.com. All rights reserved.
dv56 0.018946
Mobile Version of Website