jhmb123

Here is my size large 2018 Kona Process 153, I bought the frame back in 2019 and have built it up to my desired spec, ridden and maintained it since. It’s since had new bearings in 2021 and after that it hasn’t been ridden much. Below is the spec as it stands: hope tech 3 v4 brakes - 210mm front disc 180mm rear raceface atlas stem deity 35mm handlebar 780mm width fox factory 36 forks fox float x2 rear shock raceface arc27 rear laced to dt swiss hub boost spacing- maxxis minion dhr ii 27.5 2.4 Norco front rim boost spacing - schwalbe magic mary 27.5 2.35 burgtec thru axles sram gx shifter sram gx 10-42 11 speed cassette sram xd driver shimano xt deraileaur shimano deore xt cranks burgtec 32 tooth chainring hope pedals hope headset hope stem cap and spacers hope seat clamp generic dropper post and lever fidlock bottle mount A few things to note about the bike, I run my brakes the french way. Right hand rear brake left hand front. Also will need new sealant as the sealant in the tyres have dried up and in storage the tyres do slowly go down. Also when i replaced the linkage bearings I noticed the bash guard mount was damaged (see pictures) and one of the bolts in the linkage wasn’t in great condition. I replaced the bolt with one from a trek as with a washer it was the same size. This has worked well over the past 3 years but just something to note. I also got the bike resprayed RAL 7012 and where the kona logos are the bike is raw. The bike was also signed by Jonno and Matt Jones! This bike has been used well but maintained equally so please be aware of that. I would recommend you come and look at the bike. Will consider shipping it however if so then there won’t be any returns. I have tried to be as transparent about the condition but if you don’t come and look at it I won’t be holding fault. I am at university but can come back for serious enquiries although it may be in a few weeks and not straight away. Would prefer cash or bank transfer on collection. If you need any more information please ask.