2020 Custom USA Made Steel Hardtail, Mullet.

Beautiful custom frame from Ferrous bikes in Bellingham, Washington. Very well made in terms of the welding, braces, and gussets throughout. Yet, still lighter weight for its strength and a comfortable ride. I'm 5'11" and it fit me well with a 60mm stem as more of an all around trail frame, I ran it with a 35mm stem and took it to the pump track/dj's where it performed well there too. I put about 10 total rides on it and ran it as mixed wheel with a 130mm Pike 29 on the front. Trying to reduce the fleet to get down to a commuter and an enduro full suspension, sad to let this go, have held onto it for a year plus not wanting to do so...a scratch on bottom bracket plate where I mounted chainring too far inboard, and a 3-4mm chip on down tube. No damage underneath chain stay and seat stay wrapping.

Weight, headset and axle 6.4 lbs
Effective Top Tube Length- 24.5"
Seat tube length- 17" Routed for internal dropper
Seat tube diameter- 31.6mm Comes with DKG clamp.
Seat tube angle- 75*
Chain stay length- 16.5"
Dropout width- 148x12 comes with DT Swiss RWS
Bottom bracket width- 68mm Biggest ring you can run is 32t and maybe a 34t, at least with a Shimano XT 104 BCD
Bottom bracket height- Took it apart before I thought to measure, I remember it being around 12.5" or so.
Head tube diameter- Comes with Cane Creek Hellbender for tapered fork, I believe it's 44mm straight.
Heat tube angle- 62.5*. with approximately 535 a2c 29 fork
Head tube length- 4.35"
With Headset- 5"