I wangted a bike I could ride to the trails and still be able to go fast on and be very chuckable as the DH was becoming pointless living in the South of England. I switched frames way too often between long travel, short and meduim travel and then found this and hopefully I won't need to change frames for some time now.
Pictures
Specs Frame: Turner Rail with Pushed Fox Float R Forks: Fox 36 TALAS RC2 Rear Wheels: Black Hope Pro 2 10mm Custom Bolt Up Hub built on a Sun Rhyno Lite XL Welded Rim using Black DT Swiss Spokes and Nipples Front Wheel: Black Hope Pro 2 20mm Hub built on a Sun Rhyno Lite XL Welded Rim using Black DT Swiss Spokes and Nipples Bar: Raceface Atlas Bottom Bracket: Hope Ceramic Stem: Hope DH Stem Seat Post: Hope Eternity Brakes: Hope Mono M4's 205 Front and 185 Rear with Black Goodridge Hoses and Black Fittings Seat: SDG Bel Air Ti (I kinda swap betwwen seats a lot, depends how long I intend to ride each session) Seat Clamp: Hope Bolt Up Cranks: Raceface Atlas Pedals: Wellgo MG1's (such good pedals I'm still on my originals after 3 years) Mech: SRAM XO Short Cage Shifter: SRAM XO Grip Shift Gear Cable: Goodridge Chain: SRAM Hollow Pin Cassette: SRAM Road one Tyres: Scwable Big Betty Guey Gluey and Scwable Table Top SL Tubes: Scwable Light Weigh Ones Grips: SRAM (60mm on the right and 110mm on the left) Bar Ends: Hope Chain Guide: Mixture of Raceface Diabolus Backplate and Lower Roller and MRP Top Roller (works perfectly) Heaset: Hope Zer Stack 1.5 to 1/1/8 Reducer
Extras: Complete Set of Ti Nuts and Bolts on everything.
Weight Haven't actually weighed it properly but at a guess between 30 and 35lbs to be safe, I expect it to be nearer the 30lbs mark.
To Do List Re-route the rear brake hose internally through the frame Get the TALAS Pushed Fit another Big Betty in the rear Fit another MRP roller to the chain guide[/li][/list] Cut down the steerer Piant the Forks