FS: Chris King Aluminum Drive Shell Assembly with bearings

This came off my Chris King hub ... it's about 3 seasons old. I converted to 1x11 SRAM so got an XD Driver. As you can see it includes the bearings in the body so you don't need the $250 King Hub Tool or if your shop has one, the $80 charge. You just swap it in an out, no special tool required.

It's in fair shape, the body where the cassette goes have a few little dings especially down around where the smaller single cogs are, pretty standard fare ... cassettes still go on an off smoothly. The Driver gear is in very good shape ... this hub was used on my bike for both DH and XC so it doesn't have that many pedal miles.

The brand new unit sells fro $170 USD/$210 CDN from places like this ... http://www.avt.bike/WebStore/merchant.mvc?Screen=PROD&Store_Code=AVT&Product_Code=PHB545

Yours for way less than 1/2 off and it's a King part so they tend to last forever, I'm sure this would have happily worked for another 10 years if I didn't have to swap it for the XD driver.

Also the hub was serviced every season ... cleaned up and getting fresh grease put in so the bearings are mint.