Fox DPX Bearing Extraction Tool - 3D Printed

If you are like me, it's just not going to work paying $130 USD+ for a tool to remove bearings for servicing once a year. This set of tools is based on the Fox BRT-006 tool and intended for removal / installation of the bearing races installed at the end of the rear shock. This setup is typical of many Rocky Mountain bikes, but may also work for other shocks, however I've only tested the FOX DPX2 mated to a Rocky Mountain frame. You get 1 Extraction Tool and a pair of the Bearing Presses. Shipping to US and Canada (pm me with address for quote)

Link: https://www.etsy.com/ca/listing/1193598179/rear-shock-bearing-extraction-press-tool

Compatibility Notice: In some cases, bearing races have a different design and this tool may not work. See provided picture.

Dimensions: Bearing Press fits over bearing race with 22mm OD. If you need a different size, please send a message and I'll try to accommodate.

Check out this video for an overview of the tool usage: https://youtu.be/Fz7cyfFu4E0

These are 3D printed with Tough PLA at 100% infill. They are strong, but are not intended for shop or repetitive use. That said, I have tested these over 4 removal/installation cycles and they worked fine with minor wear. You should expect some deformation of the key contact areas over usage/time. These are tough enough to do the job as well as soft enough that they will break/deform rather than damaging the bearings.