Powered by Outside

Hubs


 Post Message | Latest Comment
Author Message
flag windyhill
Posted: Sep 12, 2017 at 10:56 Quote
I've got a dumb question. Can I run a 20 x 110 hub on 20 x 100 fork. If not do they make adapters for this?
flag RunsWithScissors
Posted: Sep 13, 2017 at 12:46 Quote
Depends on the hub. Some have interchangeable endcaps, some don't. Check you manufacturer's website and the information is probably there somewhere. If you don't find your answer on the manufacturer's website look for the "contact" link and send them a question by email. Most will answer.
flag markg1150
Posted: Sep 13, 2017 at 13:36 Quote
Wouldn't the Disc be sitting to wide.

If you take a even amount of each end to keep the rim Centred the disc will be out and if you fit uneven end caps to keep the disc right the wheel /rim would be out.

Easy going up to 110 from 100 as just need to add spacers to the ends of each hub end cap and behind the disc mounts.

Unless a wheel was designed to be adapted for both I doubt it will be doable as making a hub that did both would negate any benefit of the the extra width (not that there is any really) and cut there ability to sell new hubs.

Let us know ow what you find out?
What hubs are they?
Wouldn't mind knowing for sure myself
flag windyhill
Posted: Sep 13, 2017 at 16:09 Quote
Thanks for the help. Sent the manufacturer an email. Said that it wouldn't work.
  • Previous Page
  • Next Page

 


Copyright © 2000 - 2026. Pinkbike.com. All rights reserved.
dv65 0.006681
Mobile Version of Website