Just considering upgrading my forks, old pikes to something more modern which will be a boost size front axle fork.
My hope pro 4 are are non boost but I see there is a conversion kit for for the front hub to convert it to boost size just by using different end caps.
Just before I make the expensive decision to go ahead with a new fork I was just wondering if there any downsides to using a conversion kit for my front wheel to convert it to boost size?
I did this recently with a Hope Pro 4 front 15x100mm hub to fit Boost 15x110mm Fox 36s went for the most straight forward no hassle aproach, got a
MRP Better Boost Hub Conversion Kit, specific to Hope Pro2 and Pro4 hubs, as theres DT Swiss versions amongst others.
Theres the Hope boost kit end cap but you only get ONE end cap and are expected to re dish the wheel, blah blah etc
You could buy 2 Hope boost end caps and reduce them by 5mm each and then your wheel will be centred like the MRP, then you just have to buy the disc rotor spacer separately.
There are some others but I cant say, I just couldnt be arsed to mess around so just went with the MRP, simple straight forward, as I like it to be.
Double check and re read before you buy just to make sure your know what your getting : )
OH and down sides to a conversion kit, its extra cost, though so is a new boost wheel if your coming from a non boost, but adapter is cheaper than a new boost wheel.