na pewno kosztuje miliony Czy się myle?

 Niee, moge ci zrobic cos podobnego za 2300pln

 Brazing, a lower temperature process than welding, uses a bronze rod to create a fillet--a French word for ribbon--pronounced FILL-it It was previously thought higher welding temperatures would ruin good tubing. We now know because welding is faster, the damaging effect of higher temperature is mitigated by shorter heat duration. While disagreements about the relative merits of lower temperature vs. shorter duration continue, a properly fillet-brazed joint will certainly have greater accident "survivability." I.E., if you run into a tree or parked car, a fillet-brazed joint is less likely to fail. Either joint will withstand decades of normal use.

 Zrobilem ta rame na zamowienie wg specyfikacji klienta, w mojej galerji znajdziesz rysunek techniczny tej ramy. A ja tez sobie zerkne z ciekawosci czy zeczywiscie jest podobna.

 No zeczywiscie na pierwszy zut oka wyglada podobnie ale...geo troche inna, no i Dobermann warzy 2.4 kilo a moja 1.8 kilo... Pewnie przez to ze robia te ramy ze zwyklego 4130 Tylne haki w tych dobermanach wygladaja zajebiscie

 ok 4-5 dni

 Yes, but i would not use it for a dirt frame, its very light but not as strong as DBZ 853, it cost a lot as well

 fair enough the frame looks great, i would certainly buy one when i next want to change my dirt jump bike . whats the geometry like?

 You can find a technical drrawing in my foto album however you can get ant geo you like, any angles and sizes, tubes ect, how cool is that.

 sounds like one hell of a bargin for the money you pay, i think it will have to become my next frame when i can afford it.

 Im based in London, if you want to visit the workshop and have look how its done Im happy to do so.

 sweet might have to one day