Pinkbike.com
Powered by Outside
scotthousewpt
- Member since May 18, 2009
- O+
- Male / 44
-
Park City , Utah - 9 Followers
- 9 Trailforks Points
Riding is everything.
Recent
Selling
Feb 1, 2026 at 9:44
Feb 1, 2026Custom Santa Cruz Hightower C V2
$3000 USDFor sale here is a 2021, full custom, Santa Cruz Hightower V2 Carbon C in a size large. This bike was purchased in the spring of 2021 and ridden until the late fall of 2023. Bike was replaced with a 5010 in the spring of 2024 and was not ridden again until the summer of 2025 after a complete rebuild including bearings, Cascade Link (bike will ship with factory link as well) w/full suspension re-build and service by Suspension Syndicate in Salt Lake, new drivetrain (sans cranks), and new cable and housing. Since that re-build the bike has less than 10hrs on it. The bike has a tie-dye Slik Graphics decal package including matching hub/rim, and suspension decals. Bike also has a full Ti bolt (Oil Slick) kit from Better Bolts including all frame, brake, and stem hardware.
This bike is in great condition but has been ridden and has the usual cosmetic blemishes to be expected w/average use. I’ve done my best to represent all those blemishes/scratches in the photos. Full part spec as follows:
Frame: Carbon C V2 (Low Link Driven, new bearings less than 10hrs)
Rear Shock: Rockshox Super Deluxe Ultimate (less than 10hrs on rebuild)
Fork: Rockshox Lyric Ultimate (160mm) (less than 10hrs on rebuild)
Brakes: SRAM Code Ultimate (less than 10hrs on rebuild)
Wheels: Santa Cruz Reserve Carbon 30
Valves: Santa Cruz High Flow Tubeless
Hubs: DT Swiss 350
Tires: Maxxis Assegai 3C Maxx Grip, Double Down Casing, 2.5 (less than 10hrs)
Derailure: SRAM GX Long Cage
Shifter: SRAM GX (less than 10hrs)
Chain: SRAM XX1 Hollow Pin, Oil Slick (less than 10hrs)
Chainring: SRAM X-Sync Eagle 32T (less than 10hrs)
Cassette: SRAM XG 1295 Eagle 10-52 T (less than 10hrs)
Crank: SRAM GX
Chaine Guide: MRP AMg Alloy (less than 10hrs)
Pedals: Chromag Scarab
Seat: WTB Silverado x Santa Cruz (less than 10hrs)
Seat Post: One-Up 180mm (less than 10hrs)
Seat Post Clamp: Wolf Tooth
Stem: Chromag BZA 35 w/carbon & aluminum Wolf Tooth Spacers and top cap
Handlebar: Santa Cruz Carbon 35, 800mm (NEW, Never Ridden)
Grips: Deity Knuckle Duster (less than 10hrs)
Bottle Cage: Blackburn Composite
Bike is sold “AS IS” with NO WARRANTY, implied or otherwise (as with all used bikes).
Feel free to reach out with any questions.
Thanks for looking!
Selling
Nov 19, 2020 at 13:45
Nov 19, 2020SRAM Code R
$225 USDThis is a set (front and rear) of SRAM CODE R brakes. These are the stock brakes off a Santa Cruz Hightower V2, MY 21, size large. Brakes were never mounted/used as they were immediately replaced as part of the build. Front brake is assembled and pre-bled. Rear brake has line attached to caliper so you can run internal and then attach to master cylinder/lever. Rear brake will likely need to be bled post install. Comes with SRAM match maker clamps. Rotors NOT INCLUDED. Buyer to pay shipping. Please reach out with questions.
SOLD AS IS. NO WARRANTY IMPLIED OR OTHERWISE.
Selling
Nov 19, 2020 at 13:28
Nov 19, 2020Rockshox Super Deluxe Select +
$275 USDSelling a 2020 Rockshox Super Deluxe Select +, 210mm x 55mm, LL320 tune. This is a stock shock off of a Santa Cruz Hightower V2, MY21, size large. The shock has 4 rides on it and was then replaced with a Rockshox Super Deluxe Ultimate. The shaft has 0 rides on it as it was swapped over from the new shock. This shock was rebuilt at that time of the shaft swap with a full bleed and new fluid. Bushings are installed but you'll need reducers specific to your bike. Buyer to pay shipping. Please reach out with questions.
NO WARRANTY IMPLIED OR OTHERWISE.
Selling
Nov 8, 2020 at 14:40
Nov 8, 2020FOX 36 Performance 29"
$425 USD2020 FOX 36 Performance, FIT GRIP Damper, EVOL Sring, 29" Wheel, 44mm offset, 15x110 axle, 150mm travel, tapered steerer. This fork has NEVER been ridden. It came off a MY21 Santa Cruz Hightower and was replaced with an aftermarket fork during the bike build. Star nut is installed but the fork will need a bearing race. Small wear in steerer from removing race, not a scratch (see picture). Steerer is cut to just under 19cm/7 1/2" (see picture). This fork has never had a wheel in it or seen dirt. Sold AS IS, NO WARRANTY implied or otherwise. Buyer to pay all shipping fees based on location. Feel free to reach out with questions.



