Basically I got 3' of 3" x 1/4" flat bar and cut it into 6 pcs 6" long, 1 pc 20mm round bar x 6" long, 2 pcs 1/2" thread bar, a bunch of 1/2" washers and nuts, 8 x 1" x 3/8 NC machine screws and locknuts, 1 x old bottom bracket with the axle removed, and old pair of DH skis, 2 x BMX pegs $18 at Canadian Tire. All material cost $60.

To cut the material I used a 10" cutoff disk in my mitre saw.

I ground the 1/2" threadbar down at the rear drop out so that it would fit but still be strong.

I ground a pair of 1/2" washers down to fit inside the BB cups where the BB removal tool goes to center the pegs.

I drilled and re-tapped the pegs to fit 1/2" NC thread bar and installed in the BB shell
the 20mm round bar is for the front fork.

I took 3 pcs of 3" x 1/4" flat bar and welded them together with the axles and drilled 4 holes in the bottom to bolt an old pair of skis to.

Found some old DH skis and cut them off at 30"

It was a lot of work but worth it.

 that is f*cking intence i want to do that next year soo bad..
but yeah how would you stop just carve or like plow on the side??

 how did you build that? do you have plans and how is it like to ride?

 fucking super sick but i would think that isnt enough to keep your feet on.

 how do ya mount the pegs and whats BB

 nice lol i have some thing like that but I have a crank on min

 i have somting like identical to that exept its a hradtail

 how you stop?

 It's not a stick. It's a BB shell with spacers thread bar and BMX pegs.

 i want one!!!

 why didnt you just tighten up your bb so it wouldnt move

 I think pegs are better than cranks for this application.

 looks like a fun way to practice

 where do ur feet go?

 It rides awesome!

 thats what i did

 that is sick

 Thats so coo;

 hate that stick - the better way could be having cranks without chain...