Pinkbike.com
Powered by Outside
junipercycleworx
- Member since May 27, 2011
- FL
- Male / 36
-
Syracuse , New York - 16 Followers
- 0 Trailforks Points
Bikes, 3d printing, composites. Trying to build some sweet ass bikes
Recent
Selling
Jun 22, 2023 at 9:54
Jun 22, 2023
Like New Transition PBJ size Long
$1300 USD2023 Transition PBJ size long. Got this bike in April, hoping to squeeze in some time at the skatepark and/or goofing around in the neighborhood, but just don't have the time for it. I rode this around the neighborhood twice and took it to a skatepark once, bike hasn't seen dirt yet. Too sweet of a bike to be sitting in my garage unridden.
junipercycleworx junipercycleworx's photo
Jun 10, 2020 at 16:22
Jun 10, 2020
Yep, it was epoxied into the nylon lug. Word to the wise though, the nylon wasnt anywhere near stiff enough even when wrapped with carbon fiber.
junipercycleworx junipercycleworx's photo
Dec 15, 2019 at 8:24
Dec 15, 2019
Hey man, thanks for the interest! This is most definitely a test part, to figure out any kinks in the bladder system, and get my layup dialed in before I use carbon. I used three bladders, because the bladders I have made are limited to a tubular shape and can't get around the corners. I'm not 100% sure what pressures I had in the bladders, but they were hooked up to a 5 gallon tank at 10psi.
24,678 views
122 Photos
Favorite news
Machetes, Chickens, and Bike Checks
16 May 2014