siemon

front and rear mavic ex325disc with halo spindoctor 2 hubs. there are maxxis minions super tacky on them, front as plenty use left but rear needs replacing unless you like to get the back end out fitted new sealed cartridge bearings in front wheel only a few rides ago. rears fine and free hub fine also. rear is set up for 9mm q/r. rears also use cartridge sealed bearing along with the freehub and can be converted to solid axle with correct parts. comes with adapters for 20mm maxle and 9mm q/r on front. if you have got 15mm forks you will need to get the 15mm adapters which cost £10-£15 they run straight and true and are a very strong wheel. I am 16 stone plus and they were solid in the turns think they are set up for tubeless, just sealant and valve req. I have tubes in.

rockshox pike dual air uturn forks. 20mm maxle 1 1/8 steerer, the steerer is 186mm If it helps , my headtube with external bottom headset an zero stack top measured 141mm combined and I had a 2mm spacer on under the stem. 110-140mm adjustment motion control damper rebound adjustment lockout and adjustable floodgate very good condition very small scuff at top of one stanchion near crown and tiny nick on edging on one of the dust shields/wiper(pic) also a cable rub mark on inner leg which i did not notice happening. they hold air fine and no play in them. they have not had much use by me as purchased for my cotic build which I I did not get to use much unfortunatly.

cotic bfe large frame black grape colour. 31.6 seat post. head tube fits 1 1/8 or tapered steerer with correct headset. It has a 1 1/8 fitted currently. 73mm bottom bracket Built this bike from new frame mid 2015 and only used it for about 6 months (6 or 7 rides at cannock). then a disc in my back went and have not been able to ride since. I wrapped the frame from new in heli tape, made full patterns for near enough entire frame, so it is not just bits of tape stuck here and there. If you zoom in , you wheel see how good the fit is. Fitted are a new (when built) xt m786 2x10 front mech . left it on as were it fits frame it as slightly lifted the tape. Also (new when built) nukeproof warhead 44 iess headset for 1 1/8 steerer. With a different bottom bearing ,you can fit tapered forks also. There are only 2 tiny marks on it caused from a couple of screwdrivers falling of shelf when i banged my head on it. Think they would have been chips if not for the heli wrap. they roughly measure about 3- 4mm and as wide as a screwdrive blade. specs are here:- http://www.cotic.co.uk/product/classic_BFe26#compatibility

As title, in great condition , 1 1/8" steerer. 9mm quick release.they also include the pop loc for handle bar use, but did not have it to hand when took pictures.stanchions in very good condition, all settings work as should do. steerer is cut to 195mm.