BoiseID5point5

Renthal Fatbar Carbon C35 35mm 30 degree rise cut to 780. Ran it for about 40 miles. Great bar but switched up to a lighter stem/bar combo. (stem pictured separate for 85)

Leatt Enduro 4.0 convertible half shell/full face. I think I have worn it maybe twice so it is in like new condition zero crashes or drops. No scratches, scuffs etc. I stuck a gopro mount under the visor that is about all you can tell it is not brand new. Size small. Has their 360 degree turbine system instead of mips. Great looking helmet I just always go for my half shell or D4. New they are going for 384 bucks.

Switching up my rims on a new bike. 2026 DT Swiss XM 1700 29" wheelset. DT Swiss 350 hubs, microspline for Shimano drive. 6 bolt.

I was so preoccupied with whether or not I could, I didn't stop to think if I should. Intense Primer S size small full custom build. I spared no expense. The S was marketed as mullet or 29, and I have a 27.5 for it. Wheels: Enve M6 laced to DT Swiss 240 hubs. Bike comes with set of 29" wheels and a rear 27.5 identical Enve M6. Swap the cassette and good to go. Tires currently are Assegai 2.5 front and Aggressor 2.5 rear on both the 29" and 27.5". Drivetrain: Full SRAM XXI wireless drivetrain/cranks. Wear is light. Chain is probably due for replacement in another couple hundred miles. Brakes: SRAM Guide Ultimate 4 piston, 180 mm front and rear. The 27.5 has it's own dedicated rotor. Suspension: Fox Factory 36 Grip 2 lowered to 150mm. Fox Factory DPX2 140mm. Cockpit: Renthal Fatbar Carbon 35mm, Apex stem. Saddle is a carbon fiber Fabric. Post Fox Transfer with Wolf Tooth lever. This thing is fast. 29 pounds 11 ounces. I ran it mullet once and then 29" once and never touched the mullet setup again. It has a flip chip low/lower setting on the rear link. Always kept it in the low setting. It is a beauty in person. I am on the fence about selling it as I think I had 13-14k to build it, but just got a Spider and there is some overlap. Only really need one Boise bike and the Spider's lower travel suites my local lame trails best.

Leatt Enduro 4.0 convertible half shell/full face. I think I have worn it maybe twice so it is in like new condition zero crashes or drops. No scratches, scuffs etc. I stuck a gopro mount under the visor that is about all you can tell it is not brand new. Size small. Has their 360 degree turbine system instead of mips. Great looking helmet I just always go for my half shell or D4. New they are going for 384 bucks.

Funny story. Was switching out my stem/bar on a new bike. A bolt went missing and figured it was lost on the garage floor. Gave er a couple bounces when done and heard a weird noise. Long story short, the bolt wedged between the bridge and stanchion. Caused a large scratch on the lower stanchion. Rode it once with the scratch and it functioned fine, no problem, but not risking it. Just bought the bike so wasn't having it and bought a new fork.

Okay sweetening the pot with a bleed kit and random parts I found. Hope Tech V4s. Make an offer.

No idea. Pulled these off a bike I bought. Make an offer.

Set of 27.5 DT Swiss M1700 wheels that came with my 2019 Intense Tracer that also came with a set of carbon wheels. Never used. XD driver. Double check my axle spacing.