DucatiDavid

Selling my beloved Ibis Ripmo sized XL, which is the new large by todays standards. For reference I'm 6'-0" tall. I purchased the frame new from Backcountry.com on the middle of 2020. I installed custom colored graphics to cover all the bright orange and then wrapped the entire bike with invisiframe before building the frame. Bike has been maintained regularly and pivots greased with slick honey. Only reason for selling is I stepped up to a another bike. The bike will come as shown without the pedals. New parts on the bike are: New take off Sram Guide brakes, Brand new HS2 rotors (200mm front & 160mm rear), new take off RaceFace AR 30 offset wheels, new take off SDG dropper seat post and post lever, New take off WTB Volt seat, ODI grips, and E-thirteen handlebars 800MM wide uncut, and Sram NX 170mm crankset, chain, and 52T cassette. The bike comes with a Fox 36 Performance Elite Fork and Fox Float X2 rear shock. Shock needs service (makes a slight milkshake sound) and it will be buyers choice to either have the rear shock sent in to Fox in Asheville or I can adjust price for the cost of service. The fork has had a recent fluid and seals service completed. The rear shock has always been serviced by Fox in Asheville for the past five years at least once a year. The tires are setup tubeless with Stans with Maxxis Minion DHF 2.5WT in front. The rear is Maxxis Minion DHR II 2.4WT. Both tires have plenty of life left in them. Comes with Sram AXS GX rear derailleur and shift with upgraded paddle shifter. The rear derailleur has new jockey wheels and arm. The outside edges of the derailleur have been sanded down to bare aluminum due to scratches. I was doing this just to spruce it up a bit. It does not affect the function or performance. The handlebars are aluminum E*thirteen Base bars that are 35 mm diameter, 800mm wide with 9 degree back sweep and 5 degree rise. The stem is a FUNN billet aluminum 50mm reach and 10 degree rise. The headset is Cane Creek with Hellbender bearings that were replaced earlier in the year. The frame bearings were replaced with enduro bearing last year as well as the rear shock clevis. There are some nicks here and there in the usual places. There are no cracks in the frame and it is still under warranty with Ibis until 2026. The invisiframe has done its job protecting the frame. I have a spare set of decals to go with the frame if the buyer wishes to remove the invisiframe and put a fresh one on as I believe the decals I installed would peel off when removing. Its a great used bike and with lots of life and fun left in it for the new owner. I'm asking $2,500 OBO plus shipping & PP fees or local pickup in the WNC or Upstate area of SC. If you have any questions feel free to ask.