Pinkbike.com
Powered by Outside
mrgto
- Member since Dec 2, 2012
-
Knoxville , Tennessee - 0 Followers
- 0 Trailforks Points
Recent
mrgto mattwragg's article
May 16, 2017 at 9:04
May 16, 2017
Inside Acros
@SleepingAwake: Yes but for the price they charge for a hub I doubt the can justify a tolerance like that. That's Three ten thousandths of an inch or .000354"
I am fully aware that you can meet that tolerance on a cnc machine because I've done it but the cost is very high to machine parts that tight.
Plus, If you intended on keeping and using that tolerance you would have a machine installing your bearings not a person doing it by hand on a bench top press with a ram that is a foot long. The slop in the seals on that thing would press that bearing out of spec.
mrgto vernonfelton's article
Mar 24, 2017 at 8:02
Mar 24, 2017
Here's the Latest Long-Travel 29er Fork – Taipei Cycle Show
^^^^ This x1000!
mrgto vernonfelton's article
Mar 24, 2017 at 8:01
Mar 24, 2017
Here's the Latest Long-Travel 29er Fork – Taipei Cycle Show
Making 20mm great again!
mrgto pinkbikeaudience's article
Mar 21, 2017 at 18:23
Mar 21, 2017
MRP Ribbon Fork Now Available
Please, make 20mm axle great again!
mrgto pinkbikeaudience's article
Mar 21, 2017 at 17:56
Mar 21, 2017
MRP Ribbon Fork Now Available
@radrider: why not do it the normal way and put a plate on the back?
Nevermind, I have a fender that keeps mud out of my arch and my face.
mrgto pinkbikeaudience's article
Mar 21, 2017 at 16:53
Mar 21, 2017
MRP Ribbon Fork Now Available
@abraconn192: but it takes 2 seconds to wash my arch out with my hose if my fender falls off.
mrgto VorsprungSuspension's article
Mar 15, 2017 at 15:32
Mar 15, 2017
The Tuesday Tune Ep 17: Moar Shimz
Only if your riding a Rux.
mrgto RichardCunningham's article
Feb 7, 2017 at 17:28
Feb 7, 2017
2017 Intense Tracer - Review
@SacAssassin: Thats more than I pay a month for my 15 F350!